Wake-on-LAN must be enabled in the BIOS of the remote device. The remote device's network adapter must be enabled to allow a Magic Packet to wake the device.UDP Ports 7 and 9 must be enabled on the remote device.It is an industry standard protocol from the 1990s. The Agent must be online and in the same site and subnet as the device you would like to wake up. Wake-on-LAN (WoL) is a way to remotely reactivate a computer from a low-power mode.In Datto RMM, an Agent can send a Magic Packet to wake up a remote device if the following requirements are met: The remote device also needs to be properly configured as detailed below. In Datto RMM, Wake-on-LAN requires an online Agent in the same site and subnet as the device you wish to wake up. NOTE Magic Packets are usually sent over the entirety of a network and contain the subnet information, network broadcast address, and MAC address of the target computer’s network card, whether Ethernet or wireless. If configured, it will be able to look for a special data sequence called Magic Packet to wake up the device. If the device is in sleep mode or turned off but has access to a power source, it will continue to scan data coming in from the network. The Wake-on-LAN functionality can be especially useful when maintenance tasks, such as backups or installation of software upgrades, need to be performed on a device after business hours. It typically only works for laptops that are connected to the main supply. Wake-on-LAN is an industry standard protocol that, given that the device has access to a power source, allows for compatible devices to be turned on or awakened remotely.
0 Comments
Leave a Reply. |